Step - by - Step How to

Skid Steer T-20 Transmission Assembly . Page 4 continued

 

Click HERE to order T-20 parts off our 6x6parts.com website

The T-20 Transmission first built by Borg-Warner, and ATV-O-MATIC, now built by Skid Steer Corp. has been used in thousands of Amphibious All Terrain Vehicles including Max II, Max IV, Attex, Hustler , Starcraft, Swamp Fox, Camel and many other manufactures. It as a popular choice of custom machine builders, since it gives forward, reverse, brakes, steering all within one unit.

When it's time for service, This Step-by-Step photo guide should answer most concerns.

We offer all replacement parts at Richard's Relices Click HERE for the parts pages.

Click HERE for a nice readable copy of the factory service manual in printable PDF form.

This page is designed to be printable by ROUTE6x6 and RICHARD'S RELICS

This is another addition to our new how to series, we will ba adding more every week, so check back often. You may also e-mail suggestions for future how - to's to. richard@route6x6.com

   
T-20 Assembly Step-by-Step guide Page 4 continued
   






Left hand case.

Slide drum assembly over input shaft. and shift collar.




Note: bearing surface on ring drum must seat in case bronze bushing.

Make sure lower band does not get caught under drum.



Click on PHOTOS to see larger view

 


 

 


Install anchor pin through lower band loop and locate in bore in case.

Note: Red pointer location

Click on PHOTOS to see larger view





Install spacer on anchor pin.

 

 

Click on PHOTOS to see larger view

 

 

 

 

 

 

 

Install forward band loop over anchor pin.

Note: Red pointer location


Install bands and drums in R case too.


Click on PHOTOS to see larger view

 

 

 

 

 

 

 

We apply a thin film of RTV silcone.



Click on PHOTOS to see larger view

 

 

 

 

 

 

 

Install gasket and coat with RTV too. Install gasket on R case also.




Click on PHOTOS to see larger view

 

 

 

 

 





Dab of grease to hold thrust washer.


NOTE; Tab location.





Click on PHOTOS to see larger view

 



 

 

 

 

 

 

Thrust washer installed


Note: Red pointer location



 

 

 

 

 

 

 Installed center plate over input shaft and through drum.

Note: Red pointer location of band anchor pin in center plate


Click on PHOTOS to see larger view   



 

 

 

 

 

 

 Install thrust washer, locate tab in notch.

Note: Red pointer location


 

 

 

 

 

 

 

 Install sun gear

Note: Red pointer location


Click on PHOTOS to see larger view   


 

 

 

 

 

 

 

Install C clip using channel locks

 
   

Go back to PAGE 3

Go back to PAGE 5

   

If you have any questions, you welcome to contact us at richard@route6x6.com
or call 812-944-1643 8am-6pm weekdays and will will help you.

Replacement parts available at RICHARD'S RELICS ATV Transmission parts page